Mercedes were the most improved team
throughout 2013 as they made infrastructure changes in order to meet
the challenges faced by the 2014 regulations. One of their
development areas that levied a performance gain was the front wing,
therefore it's no surprise to see the WO5 feature a similar design.
However with the team taking into account the overall width reduction
of 150mm (75mm either side) we see that the wing does bear several
differences to it's predecessor. All of these changes are keyed at
moving airflow outbound of the front tyre, making up for the loss of
surface area.
Adorning the secondary section of the
Endplate (Mercedes split their Endplate into sections) the team have
added a horizontal blade [1]. The wing shaped appendage creates a
pressure gradient as the airflow passes over it enhancing the airflow
structure created by the footplate below and Endplates it's attached
to, all of which help to outwardly turn the airflow.
Added to the main cascade we find a new
cascade element [2] which again is aggressively angled in order to
turn the airflow outbound. The inner edge of this cascade resides in
the same position that was occupied by an 'r' cascade in 2013 who's
job it was to enhance the Y250 Vortex. With this gone the shaping of
the rearward flaps has been adjusted to mimic it's effect.
The main cascade now features a
vertical strake [3] which it's job is again to turn the airflow
outbound (note also how the thickness of this element changes at it's
base to the upper tip, as this will undoubtedly roll up the airflow
into a vortice)
What is the function of the little 'ball' next to the vertical strake?
ReplyDeleteMartin
That is an IR camera
DeleteThe powers that be claim to want to cut costs in F1 and they still allow these stupid monstrosities of aero appendages, which cost millions to research in the wind tunnel and then to manufacture - many of course needed as the drivers nerf the end bits off in the first corner. Cut aero, including DRS, fit wider tyres and allow the drivers to try and control the resulting mechanical grip advantage over aero and we might just get back to the racing show that used to be.
ReplyDeleteEliminating aero development is not how one addresses expensive costs, because money can always be spent. A budget cap (properly written and enforced) is the best way to allow technological freedom and ingenuity to reward the smartest and not the richest teams.
DeleteAgree re budget cap, but my main point was the control of aero development and manufacture, which has destroyed competition and costs a ridiculous amount of money. See articles by Gary Anderson to understand how much the new regs will cost teams in design and manufacture of new rear wings for example.
DeleteThe little ball is a thermal camera. To check tire temps.
ReplyDeleteCorrect, its a thermal imaging camera
DeleteSomers, could you comment on how you think the different elements (be it front wing, rear wing, exhaust, etc.) will perform comparatively between teams?
ReplyDeleteThe same as it has always been, those that have the infrastructure and funds to refine their concepts whilst also learning from those around them will triumph.
Delete